This will keep your error at minimum.ģ) Add all 25 charges for a total amount of grains.Ĥ) Divide the total amount of grains of the 25 charges by 25. If you slam or knock your press when loading start again with the three cycle procedure before you continue to load. It is a good practice with the Auto Disk to always throw the first 3 charges and dump them back into the bottle to settle your powder and never disturb the powder in the hopper when loading by dumping into it. Write each down in a list, and don't cheat. Take the formula that Lee gives: Charge in grains X VMD Factor = Volume CCġ) Put the largest disk cavity in position to throw charges, mine is 1.57 CCĢ) Take the powder batch you want to get an accurate VMD for, Cycle your press the same way you do when loading and throw and measure a quantity of charges, 25 is a good total and measure each precisely on a good scale. You can fight your way out of this problem by establishing your own VMD factor for the powder batch you are using in your measure and the way you have it set-up. Could this be a typo in the Die set load data?įor comparison the closet Lyman 49th load is to get to the starting load (4.5) I have to jump up to the. 40 disk and it throws about 4.1g of powder. 40 Auto-Disk (In the description portion of the insert that comes with the dies is indicates the Auto-Disk listed for any of the loads is the "Largest Cavity to be used with the Lee Auto-Disk Powder Measure") I am using the insert that comes with the Lee 4-Die carbide die set for the load data, a Lee Pro Auto Disk and W231 Powder. I have some Lee TL230 Boolits I have cast from W/W's for 45ACP. 45ACP and my first time using the Lee Auto-Disk measure. Hi all, I am looking for some insight on a problem I am having with my first attempt at casting/reloading for.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |